Picture View of all Bolts, Screws
and Other Parts Supplied with the Antenna
Model 75-E Antenna Assembly and
Universal Mount/Mast Assembly not shown above.
Round Disc is Rear Mount Assembly. Top Rectangular Tube is
Feed Support Arm.
Bottom Left shows the INTEGRATED 75-E QUAD LNBF Assembly and rubber
cable cover just above. Other parts are enclosed inside a plastic bag.
UNIVERSAL MOUNT & MAST
ASSEMBLY, Supplied With System
2.0 inch outside diameter mast pipe matches mounting clamp on
antenna. Should be installed securely and perfectly vertical (check
with a level). End User supplies lag screws or other fasteners appropriate for
their situation.
BACK VIEW of assembled Satellite
Dish.
The "disc" can be rotated for proper "skew"
setting of Antenna.
Center or Factory setting is at 90 degrees.
Should be aligned for Skew Angle given for your location, and
secured.
Do NOT neglect to install the
Plastic Spacer inside the dish end of the feed arm. It needs to be in there for proper support, especially after
tightening the hardware.
Assembled 75-E Antenna, with QUAD
LNBF installed.
Some Installation Notes:
Secure the ground lug to a spare hole adjacent to the curved slot at
the base of the Mast Mount. Remove surface paint if necessary
to allow proper grounding.
INSTALL THE TOOTH WASHER BETWEEN THE GROUND LUG AND UNIVERSAL MOUNT
& MAST ASSEMBLY, and fasten securely to provide proper
grounding.
Previous instructions mention a 2 x 2 Multiswitch. It is NOT
used or required when using the Dual Satellite Integrated Quad LNBF
supplied with this system. Use of a power divider or splitter
for QUAD LNBF signal distribution is NOT recommended. Each
receiver must be connected DIRECTLY with a single cable to any of
the QUAD LNBF ports (2 connections for DSR-530 PVR).
Multi-switch function is built into the logic of the QUAD LNBF, and
when dish is properly aligned, and STAR CHOICE has properly mapped
your Satellite Receiver for Dual Satellite, Non-Stacked Type, all
switching will be automatic.
The 75-E QUAD LNBF is specifically designed for use with this 75 cm
Elliptical Antenna. Do NOT attempt to install it on any other
antenna, and do not try using the QUAD LNBF supplied for the 60-E
elliptical antenna on this antenna. Each is designed as a
matched set, and will not work on other systems. The proper
QUAD LNBF for the 75-E antenna is model number LM-2738-75SC.
Installation should be set up using Channel 299 on Anik F1R
satellite (107.3
West). Once system is activated, signal level should be re-checked on Channel
260,
which is on the Anik F2 satellite (111.1 West) and can be used for
its alignment.
Maximum cable distance between the QUAD LNBF and any receiver is 150
feet, when used with quality RG-6 (60% braid) type cable.
There is no minimum cable length requirement. Longer distances
should use RG-11 or heavier cable, after confirming the most
suitable type from a qualified technician.
Unused LNBF ports do not need to be terminated, but should use the
rubber protector supplied with the QUAD LNBF to minimize exposure to
moisture and environment.
Do NOT use In-Line Satellite Amplifiers with the QUAD LNBF system,
as they will interrupt normal functionality.
